The MESHES program that allows you to extract rigged mesh from SL
MESHES-GOONSQUAD EDITION
Thread Started By ZeroThe10th
- 161027
- 153
- Rate Thread
Page 13 (The above is first post of this thread) |
04-12-2019, 10:18 PM
Iiiiii hope I figure this out but dang you guys are smart, I can barely maneuver sl yet and you can make super awesome programs omg
04-13-2019, 10:43 AM
(This post was last modified: 04-13-2019, 03:20 PM by flyteoffaith.)
Hi everyone, I decided to try this again as I failed so bad last time :P ok, so I downloaded the new version of Meshes and started to follow the lovely vid by Zero, but I didnt get far. When I got to the part I need to enter a location for "xml file to read" it takes me to the one just created by Meshes, Init.xml, I click to open it but then I get an error message........ File C:\Users\Faith\Desktop\Meshes sl\Init.xml malformed........ so I'm kinda stuck again.
I had the earlier version of meshes installed but I'm pretty sure I deleted it.
Anyone seen this ? any ideas what I should do ?
EDIT..... damn ! finally I get it :) I was struggling to hear what Zero said, I thought she meant the xml file that came with meshes but its actually the file you export from sl......doh !
I had the earlier version of meshes installed but I'm pretty sure I deleted it.
Anyone seen this ? any ideas what I should do ?
EDIT..... damn ! finally I get it :) I was struggling to hear what Zero said, I thought she meant the xml file that came with meshes but its actually the file you export from sl......doh !
1 Guest(s)
Share this: